Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Syntax
POWer:SWLoss:
REFLevel:ABSolute:LOWCurrent <NR3>
POWer:SWLoss:REFLevel:ABSolute:LOWCurr ent?
Arguments
<NR3> is a floating point number that specifies the low voltage current level in
amperes.
Examples
POWER:SWLOSS:REFLEVEL:ABSOLUTE:LOWCURR ENT 2 .8 sets the absolute
reference low current to 2.8000 A.
POWER:SWLOSS:REFLEVEL:ABSOLUTE:LOWCURR ENT ? might return
:POWER:SWLOSS:REFLEVEL:ABSOLUTE:LOWCUR RENT 5.0000 indicating that
the absolute reference low current is set to 5.0000 A.
POWer:SWLoss:REFLevel:ABSolute:LOWVoltage
This command specifies the low voltage reference level used in switching loss
power measurements in volts.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:SWLoss:REFLevel:ABSolute:LOWVolt age <NR3>
POWer:SWLoss:REFLevel:ABSolute:LOWVolt age?
Arguments
<NR3> is a floating point number that specifies the low voltage reference level
in volts.
Examples
POWER:SWLOSS:REFLEVEL:ABSOLUTE:LOWVOLT AGE 2 .5 sets the absolute
reference low voltage to 2.5000 V.
POWER:SWLOSS:REFLEVEL:ABSOLUTE:LOWVOLT AGE ? might return
:POWER:SWLOSS:REFLEVEL:ABSOLUTE:LOWVOL TAGE 5.0000 indicating that
the absolute reference low voltage is set to 5.0000 V.
POWer:SWLoss:REFLevel:PERCent:GATEMid
This command specifies the mid voltage reference level used in switching loss
power measurements in percent.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-525

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English