Commands Listed in Alphabetical Order
RF:PRObe:CAL
ibrate:STATE? (Query Only)
This command returns the calibration state of the probe connected to the RF input.
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
RF:PRObe:CALibrate:STATE?
Returns
DEFAULT — Not calibrated
COMPensated — Last calibration passed
RUNNING — Probe calibration is in progress.
Examples
RF:PRObe:CALibrate:STATE? might return DEFAULT, indicating that the
probe is not calibrated.
RF:PRObe:COMMAND
This command sets the state of the probe control specified with the first argument
to the state specified with the second argument. The commands and states are
unique to the attached probe type. See the probe documentation for how to set
these string arguments.
The command form takes 2 string arguments: the first is the probe command
enumeration and the second is the data value.
The query form requires a single quoted string argument to specify the probe
command enumeration for which the response data is requested.
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
RF:PRObe:COMMAND <QString>, <QString>
RF:PRObe:COMMAND? <QString>
Arguments
<QString> are quoted strings specifying the probe command and value to set in
the probe attached to the specified channel.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-565
To Next Page
Loading...
Need help?
General
