Commands Listed in Alphabetical Order
PASSED indicat
es the probe is degaussed.
FAILED indicates the degauss operation failed.
RUNNING indicates the probe degauss operation is currently in progress.
Examples
RF:PROBE:DEGAUSS:STATE? might return FAILED, indicating the degauss
operation failed.
RF:PRObe:FORCEDRange
This command specifies the range of a TekVPI probe attached to the RF input.
Conditions
MDO3
000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
RF:PRObe:FORCEDRange <NR3>
RF:PRObe:FORCEDRange?
Arguments
<NR3> is a floating point number that specifies the range, which is probe specific.
Returns
The query form of this command returns 0.0 for probes that do not support
forced ranges.
RF:PRObe:GAIN
This command specifies the scale factor for the probe attached to the RF input.
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
RF:PRObe:GAIN <NR3>
RF:PRObe:GAIN?
Arguments
<NR3> is a floating point number that specifies the probe scale factor. Allowed
values depend on the specific probe.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-567
To Next Page
Loading...
Need help?
General
