Commands Listed in Alphabetical Order
Syntax
RF:RF_AMPlitu
de:LABel <QString>
RF:RF_AMPlitude:LABel?
Related Commands
RF:RF_FREQuency:LABel, RF:RF_PHASe:LABel, RF:LABel
Arguments
<QString> is a quoted string of up to 32 characters.
RF:RF_AMPlitude:VERTical:POSition
This command specifies the vertical position of the RF Amplitude vs. Time trace.
The position value determines the vertical graticule location at which thetrace
is displayed. Increasing the position value of a waveform causes the waveform
to move up. Decreasing the position value causes the waveform to move down.
The minimum is -50 divisions and the maximum is 50 divisions with a resolution
of 0.02 divisions.
Conditions
MDO4000/B/C models only.
Group
RF
Syntax
RF:RF_AMPlitude:VERTical:POSition <NR3>
RF:RF_AMPlitude:VERTical:POSition?
Arguments
<NR3> is a floating point number.
Examples
RF:RF_AMPlitude:VERTical:POSition —1 sets the vertical position of the
RF Amplitude vs. Time trace to -1 division.
RF:RF_AMPlitude:VERTical:POSition? might return 0.0E+0, indicating a
vertical position of 0.
RF:RF_AMPlitude:VERTical:SCAle
This command specifies the vertical scale for the RF Amplitude vs. Time trace.
For a signal with constant amplitude, increasing the scale causes the waveform to
be displayed smaller. Decreasing the scale causes the waveform to be displayed
larger.
Conditions
MDO4000/B/C models only.
2-574 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
