Commands Listed in Alphabetical Order
Conditions
This command re
quires a DPO4AUTO or DPO4AUTOMAX application module
on DPO/MSO4000B and MDO4000/B/C models and a MDO3AUTO application
module on MDO3000 models.
FORMERRor, ANYERRor, FDBRS, and FDESI are only supported on MDO3000
and MDO4000C models and available only when :BUS:B<x>:CAN:STANDard
is set to
CANFD.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CA N:CONDition
{SOF|FRAMEtype|IDentifier|DATA|IDANDDA TA|EOF|ACKMISS|ERROR|
FORMERRor|ANYERRor|FDBRS|FDESI}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CA N:CONDition?
Arguments
SOF specifies a search based on the start of frame.
FRAMEtype specifies a search based on the frame type.
IDentifier specifies a search based on the frame identifier.
DATA specifies a search based on the frame data.
IDANDDATA specifies a search based on the frame identifier and data.
EOF specifies a search based on the end of frame.
ACKMISS specifies a search based on the missing ACK field.
ERROR specifies a search based on bit stuffing errors.
FORMERRor specifies a search based on packet form errors.
ANYERRor specifies a search based on matching any packet error (missing ACK,
or form error).
FDBRS specifies a search based on a CAN FD frame’s BRS bit.
FDESIspecifies a search based on a CAN FD frame’s ESI bit.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:DIRection
This command sets the data direction (read, write or nocare) to be used to search on
CAN bus data. This only applies if the search condition has been set to IDentifier
(using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:CONDition).
SEARCH<x> is the search number, which is always 1, and B<x>is the bus number
(1-4). 1-3 for the MDO4000C and 1-2 for the MDO3000.
2-624 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
