Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
SEARCH:SEARCH
1:TRIGGER:A:BUS:B1:FLEXRAY:CYCLECOUNT:VAL UE?
might return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:CYCLECOUNT:VALUE
"XXXXXX"
indicating the cycle count value is don't cares.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:DATa:HIVALue
This command specifies the high value to use when searching on the
FlexRay bu
s data field. The search condition needs to be set to ID or
IDANDDATA (using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:
CONDition).
SEARCH<x> is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:DATa:HIVALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:DATa:HIVALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:CONDition
Arguments
<QString> is a quoted string that is the data field high binary value.
Examples
SEARCH:SEARCH1:TRIG
GER:A:BUS:B1:FLEXRAY:DATA:HIVALUE
“11001010”
sets the high value 11001010.
SEARCH:SEARCH1:TRI
GGER:A:BUS:B1:FLEXRAY:DATA:HIVALUE?
might
return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRAY:D ATA:HIVALUE
"XXXXXXXX"
indicating the high value is don't cares.
SEARCH:SEARCH<x>:
TRIGger:A:BUS:B<x>:FLEXray:DATa:OFFSet
This command specifies the offset of the data string in bytes to be used when
searching on the FlexRay bus data field. The search condition needs to be set to
ID or IDANDDATA (u
sing SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:
FLEXray:CONDition).
SEARCH<x> is the search number, which is always 1, and
B<x>
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-651

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English