Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
SEARCH:SEARCH
1:TRIGGER:A:BUS:B1:FLEXRAY:HEADER:CRC?
might
return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRAY: HEADER:CRC
"XXXXXXXXXXX"
indicating the CRC protion of the binary header string is don't
cares.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:HEADER:CYCLEcount
This command specifies to use the cycle count portion of the binary header string
when searc
hing on the FlexRay bus header. The search condition needs to be set
to HEADer (using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:
CONDition).
SEARCH<x> is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:HEADER:
CYCLEcount <QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:HEADER:
CYCLEcount?
Arguments
<QString> is a quoted string representing the cycle count portion of the binary
header string used for FlexRay search.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:HEADER:CYCLECOUNT
“001101”
sets the cycle count to 001101.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:HEADER:CYCLECOUNT?
might return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:HEADER:CYCLECOUNT
"XXXXXX"
indicating the cycle count is don't cares.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:HEADER:FRAMEID
This command specifies to use the frame I
D portion of the binary header string
when searching on the FlexRay bus header. The search condition needs to be set
to HEADer (using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:
CONDition).
SEARCH<x> is the search number, which is always 1, and B<x> .
2-660 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English