Commands Listed in Alphabetical Order
Arguments
<NR1> is the len
gth of the data string in Bytes.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:RS232C:TX:DATa:VALue
This command specifies the data value to be used for an RS-232 search, if the
condition is
set to
RXDATA. SEARCH<x> is the search number, which is always
1, and
B<x>
Conditions
This command requires a DPO4COMP application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3COMP application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:RS 232C:TX:DATa:VALue
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:RS 232C:TX:DATa:VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:RS232C:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:SPI:CONDition
This command specifies the search condition for a SPI search. SEARCH<x> is the
search number, which is always 1, and
B<x>
Conditions
This command requires a DPO4EMBD application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3EMBD application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:SP I:CONDition
{SS|STARTofframe|MISO|MOSI|MISOMOSI}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:SP I:CONDition?
Related Commands
BUS:B<x>:SPI:IDLETime,
BUS:B<x>:SPI:FRAMING
2-698 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
