Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
SEARCH:SEARCH
1:TRIGGER:A:BUS:B1:USB:ENDPOINT:VALUE?
might return
:SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:E NDPOINT:VALUE “1001”,
which indicates that the binary address is 1001 (09 hex).
SEARCH:SEAR
CH<x>:TRIGger:A:BUS:B<x>:USB:ERRTYPE
This command specifies the error type to search for in a USB search, when the
search condition is set to
ERRor. SEARCH<x> is the search number, which is
always 1, a
nd
B<x>
Conditions
This command requires the DPO4USB application module to be installed, except
for MDO3000 models, which require the MDO3USB. Note that 1 GHz bandwidth
models are recommended for high-speed (HS) USB.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:ERRTYPE
{PID|CRC5|CRC16|BITSTUFFing}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:US B:ERRTYPE?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:USB:CONDition
Arguments
PID indicates the error type is set to packet ID.
CRC5 indicates the error type is set to 5-bit CRC.
CRC16 indicates the error type is set to 16-bit
CRC.
BITSTUFFing indicates the error type is set to bit stuffing.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:CO NDITION PID sets the error
search condition to packet ID.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:CO NDITION? might return
:SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:C ONDITION PID, indicating
the error search condition is packet ID.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:USB:HANDSHAKEType
This command specifies the handshake type to be use
dinaUSBsearch.
SEARCH<x> is the search number, which is always 1, and B<x>
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-707

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English