Commands Listed in Alphabetical Order
Arguments
ANY indicates a
ny of the token types.
SOF indicates a SOF (start-of-frame) token type
OUT indicates an OUT token type.
IN indicates an IN token type.
SETUP indicates a SETUP token type.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:TO KENTYPE SETUP sets the
token type to SETUP.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:TO KENTYPE? might return
:SEARCH:SEARCH1:TRIGGER:A:BUS:B1:USB:T OKENTYPE SOF if the token
type is SOF.
SEARCH:SEARCH<x>:TRIGger:A:BUS:SOUrce
This command specifies the source of a bus search. <x> is the search number.
SEARCH<x> is the search number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:SOUrce {B1|B2|B3|B4 }
SEARCH:SEARCH<x>:TRIGger:A:BUS:SOUrce?
Arguments
B1 specifies the Bus 1 source.
B2 specifies the Bus 2 source.
B3 specifies the Bus 3 source.
B4 specifies the Bus 4 source.
SEARCH:SEARCH<x>:TRIGger:A:EDGE:SLOpe
This command specifies the slope to be used in an edge search: rising, falling
or either. <x> is the search number.
SEARCH<x> is the search number, which
is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:EDGE:SLOpe {RISe|FALL|E ITHer}
SEARCH:SEARCH<x>:TRIGger:A:EDGE:SLOpe?
2-716 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
