Tektronix MDO3000 Series - Page 749

Commands Listed in Alphabetical Order
Conditions
MDO4000/B and M
DO4000C with option SA3 or SA6 only.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LEVel:RF_AM Plitude
{<NR3>|ECL|TTL}
SEARCH:SEARCH<x>:TRIGger:A:LEVel:RF_AM Plitude?
Arguments
<NR3> is a floating point number that sets the threshold level, in Volts, to use
when searching on the RF Amplitude vs. Time trace.
ECL sets the threshold level to a preset ECL high level of -1.3V.
TTL sets the threshold level to a preset TTL high level of 1.4V.
SEARCH:SEARCH<x>:TRIGger:A:LEVel:RF_FREQuency
This command sets the threshold level to use when searching on the RF Frequency
vs. Time trace.
Conditions
MDO4000/B and MDO4000C with option SA3 or SA6 only.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LEVel:RF_FR EQuency
{<NR3>|ECL|TTL}
SEARCH:SEARCH<x>:TRIGger:A:LEVel:RF_FR EQuency?
Arguments
<NR3> is a floating point number that sets the threshold level, in Volts, to use
when searching on the RF Frequency vs. Time trace.
ECL sets the threshold level to a preset ECL high level of -1.3V.
TTL sets the threshold level to a preset TTL high level of 1.4V.
SEARCH:SEARCH<x>:TRIGger:A:LEVel:RF_PHASe
This command sets the threshold level to use when searching on the RF Phase
vs. Time trace.
Conditions
MDO4000/B and MDO4000C with option SA3 or SA6 only.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-719