Commands Listed in Alphabetical Order
Related Commands
TRIGger:A:LOG
Ic:THReshold:RF
Examples
SEARCH:SEARCH1:TRIGger:A:LOGIc:THResho ld:RF_FREQuency
1.00E+6
sets the search’s threshold to 1 MHz.
SEARCH:SEARCH1:TRIGger:A:LOGIc:THResho ld:RF_FREQuency? might
return 1.00E+6, indicating that the search’s threshold is 1 MHz.
Following is an example command sequence showing how to generate a single
search mark on the RF_FREQuency waveform when the waveform is logic 0
(less than 1 MHz):
SEARCH:SEARCH1:TRIGger:A:LOGIc:THResho ld:RF_FREQuency
1.00E+6
SEARCH:SEARCH1:TRIGger:A:LOGIc:INPut:R F_FREQuency LOW
SEARCH:SEARCH1:STATE 1
SEARCH:SEARCH1:LIST? :SEARC H:SEARCH1:LIST
RF_FREQuency,2.4702,2.4702,2.4702,-19. 0119E-6,0.0E+0,0.0E+0,
0.0E+0
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THReshold:RF_PHASe
This command specifies the threshold, in degrees, to use when
searching the RF Phase vs. Time waveform. (It does the same thing as
SEARCH:SEARCH<x>:TRIGger:A:LOWerthresh old:RF_PHASe.) This
command is used together with SEARCH:SEARCH<x>:TRIGger:A:LOGIc:
INPut:RF_PHASe to search for an instance when the RF Phase vs. Time
waveform goes higher or lower than the specified threshold.
SEARCH<x> is the
search number, which is always 1.
Conditions
MDO4000/B/C models only.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THRes hold:RF_PHASe {<NR3>}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THRes hold:RF_PHASe?
Related Commands
TRIGger:A:LOGIc:THReshold:RF
Examples
SEARCH:SEARCH1:TRIGger:A:LOGIc:THResho ld:RF_PHASe 4.500E+1
sets the search’s threshold to 45 degrees.
2-730 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
