Tektronix TBS2000B Series

4. Use the Multipurpose knob to select and click Autoset Enable. The
oscilloscope opens the Feature Enable password entry screen.
5. Use the Multipurpose knob and side-menu buttons to enter the password
that lets you disable Autoset. The factory default password is 000000.
6. Push OK side-menu button to enter the password and let you disable Autoset.
How to change the Autoset password
Use this procedure to change the Autoset enable/disable password. Autoset
requires a password to enable or disable the Autoset mode.
1. Push Utility.
2. Push -More- Page 1/2 side-menu button.
3. Push Feature Enable side-menu button.
4. Use the Multipurpose knob to select and click Autoset Enable.
Acquisition setup
TBS2000B Series Oscilloscopes User Manual 71