Tektronix TBS2104B

Setting the probe attenuation factor
Attenuation is the amount that the probe reduces or amplifies the input signal
amplitude before sending it to the oscilloscope input. The Attenuation submenu
sets the probe attenuation factor for probes that do not have the TekProbe II or
TekVPI interface. The default attenuation is 10x.
1. Push the Vertical Menu button for the channel input that you want to set.
2. Push the Probe Setup side menu to display the Probe Setup submenu.
3. Use the Multipurpose knob to select and click the Attenuation submenu
item.
4. Use the Multipurpose knob to select and change the attenuation factor.
Setting channel input parameters
TBS2000B Series Oscilloscopes User Manual 51