Autoset tips
■
If more than one channel is active, Autoset triggers on the lowest-numbered
displayed channel, and displays all active channels from the top to the bottom
of the screen.
■
Autoset always sets vertical offset to 0 V.
■
Channel 1 is a special case: If all channels are off (not displayed), or channel
1 is on, Autoset attempts to detect, trigger, and display the waveform for
channel 1 even if no signal is present (resulting in a flat waveform for
channel 1). It will not trigger on, or display the other channels, even if there
are signals present on those channels.
Acquisition setup
TBS2000B Series Oscilloscopes User Manual 69
To Next Page
Loading...
