Saving and Recalling Waveforms
TDS 420A, TDS 430A, TDS 460A & TDS 510A User Manual
3–107
Figure 3–57: More Menu
To Recall a Waveform From Disk
To recall a waveform from disk to an internal reference memory, press save/re-
call WAVEFORM
➞ Recall Wfm To Ref. Then use the general purpose knob
to select the exact file from the resulting scrollbar list. Finally, press To Ref1, To
Ref2, To Ref3, or To Ref4 to complete the operation.
To Select the Save Format (TDS 400A Only)
To select the format that the oscilloscope uses to save waveforms to a file, press
save/recall WAVEFORM
➞ Save Format (main) ➞ Internal, MathCAd, or
Spreadsheet
(side) (see Figure 3–58). Three formats are available:
Internal creates files (.WFM) in the internal format of the oscilloscope.
MathCad creates files (.DAT) in a format usable by MathCad
.
To Next Page
Loading...
