Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–185
specifies that limit testing of waveforms is in effect.
returns either or , indicating whether limit testing of waveforms is in effect.
LIMit:TEMPLate (No Query Form)
Creates a template which you can use for limit testing. You can compare the
waveform acquired through the specified channel against this template. The
template can be a waveform saved in any of the reference locations REF1
through REF4, or none.
Limit Test
LIMit:TEMPLate:DESTination, LIMit:TEMPLate:SOUrce
creates a template with the specified source waveform and tolerances, and
stores it in the destination reference waveform to be used in limit testing
comparisons.
creates a template with the specified source waveform and tolerances, and stores
it in the destination reference waveform to be used in limit testing comparisons.
LIMit:TEMPLate:DESTination
Sets or queries the destination reference waveform that the LIMit:TEMPLate
STORe command will use.
Limit Test
LIMit:COMPARE:CH<x>, LIMit:TEMPLate, LIMit:TEMPLate:SOUrce
Examples
Group
Related Commands
Syntax
Arguments
Examples
Group
Related Commands
Syntax
To Next Page
Loading...
