Tektronix TDS 420A - Page 226

Command Descriptions
2–212
TDS Family Oscilloscope Programmer Manual











 specifies the falling edge.
 specifies the rising edge.
 
specifies that the rising edge be used for the immediate delay measurement.

returns either  or .
MEASUrement:IMMed:DELay:EDGE2
Sets or queries the slope of the edge that is used for the delay “to” waveform
when taking an immediate delay measurement. The waveform is specified by
MEASUrement:IMMed:SOURCE2.
Measurement
MEASUrement:IMMed:SOURCE2
  !  "












 specifies the falling edge.
Arguments
Examples
Group
Related Commands
Syntax
Arguments