Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–225
is an input channel.
is a math waveform.
is a reference waveform.
is a histogram (TDS 500C and 700C only).
sets channel 1 as the delay “to” source when making delay measurements.
might return .
MEASUrement:MEAS<x>:STATE
Controls the measurement system. The source specified by MEASUre-
ment:MEAS<x>:SOURCE1 must be selected for the measurement to be
displayed. The source can be selected using the SELect:CH<x> command.
Measurement
! " " #
Arguments
Examples
Group
Syntax
To Next Page
Loading...
