Tektronix TDS 420A - Page 286

Command Descriptions
2–272
TDS Family Oscilloscope Programmer Manual
Trigger
HORizontal:DELay:MODe, HORizontal:DELay:TIME:RUNSAfter,
HORizontal:DELay:TIME:TRIGAfter
TRIGger:DELay:TIMe <NR3>
TRIGger:DELay:TIMe?
TRIGger :
:
DELay
?
<Space>
<NR3>
TIMe
<NR3> is the delay time, in seconds.
TRIGGER:DELAY:TIME 4E-6
sets the delay time to 4 ms.
TRIGger:DELay:TYPe
Sets or queries the type of delayed trigger.
Trigger
TRIGger:DELay:TYPe EDGE
TRIGger:DELay:TYPe?
TRIGger :
:
DELay
?
<Space>
TYPe
EDGE
EDGE is a normal trigger. A trigger event occurs when a signal passes through a
specified voltage level in a specified direction. Use the TRIGger:DELay:LEVel
and TRIGger:DELay:EDGE:SLOpe commands to set the voltage level and
direction respectively.
TRIGGER:DELAY:TYPE?
always returns EDGE as the type of delayed trigger.
Group
Related Commands
Syntax
Arguments
Examples
Group
Syntax
Arguments
Examples