Tektronix TDS2024 Manual

Maintenance
6-- 26
TDS1000 and TDS2000 Series Digital Storage Oscilloscopes Service Manual
You will need a torque-limiting Torx T-15 screwdriver and a flat-blade screw-
driver for this procedure.
Removal. To remove the front-panel module, refer to Figure 6--16 and follow
these steps:
1. Remove the power button and rear case using the procedures on pages 6--10.
2. Remove the entire internal assembly from the front case using the procedure
on page 6--17.
3. Disconnect the front-panel ribbon cable at J202 on the main board by pulling
straight up from the connector.
4. Remove the four screws attaching the front-panel module to the internal
assembly.
5. Pull the module away from the internal assembly.
Internal
assembly
Main
board
Front-panel
ribbon cable
Front-panel module
Figure 6--16: Removing the front-panel module
Front-Panel Module

Tektronix TDS2024 Specifications

General

Channels	4
Bandwidth	200 MHz
Sample Rate	2 GS/s
Record Length	2.5k points
Vertical Resolution	8 bits
Vertical Sensitivity	2 mV/div to 5 V/div
Timebase Range	5 ns/div to 50 s/div
Display Resolution	320 x 240 pixels
Math Functions	Add, Subtract, Multiply, Divide, FFT
Input Coupling	AC, DC, GND
Trigger Modes	Auto, Normal, Single
Trigger Types	Edge, Video, Pulse
Connectivity	USB
Input Impedance	1 MΩ
Maximum Input Voltage	300 V
Interface	USB
Power Supply	100 to 240 V
Dimensions	326 mm x 158 mm x 124 mm