Tektronix TDS3032B User Manual

Appendix D: Probe Basics
D-2
TDS3000B Serie s User Manual
Probe Compensation
You should compensate a probe to an oscilloscope input whenever
you attach a probe for the first time to any i nput cha nnel. See
page 1--3 for instruc tions to compensate probes.
When compensating the P3010, only a djust the trimmer marked L.
L
TekProbe Interface
Probes with the TekProbe interface automatically communicate with
the oscilloscope to set the probe type and attenuation factor. If you
use a probe without the TekProbe interface, you can set these
parameters in the Vertical menu for the channel that the probe is
connected to.

Tektronix TDS3032B Specifications

General

Brand	Tektronix
Model	TDS3032B
Category	Test Equipment
Language	English