Maintenance
TDS3000B Series Service Manual
6-39
Troubleshooting
This section contains information and procedures to help you isolate a defective
module in a TDS3000B series oscilloscope.
WAR NING . Before doing this or any other procedure in this manual, read the
General Safety Summary and Service Safety S ummary found at the beginning of
this manual. Also, to prevent possible injury to service personnel or damage to
electrical components, read Preventing ESD on page ix.
If you replace the main board, you must adjust the instrument after repair. Refer
to the chapter Adjustment Procedures for information about adjustment.
You need the the following equipment to troubleshoot the instrument.
Tools and Equipment Example
DMM 3.5 or greater digit DMM
Adjustment After R epair
Required Tools and
Equipment
To Next Page
Loading...
