Maintenance
TDS3000B Series Service Manual
6-7
You will need the following tools t o remove and replace all the modules in the
oscilloscope.
H Torque-limiting screwdriver, 12 in ⋅ lb (1.3 N ⋅ m) range with Torx® T-10
and T-15 tips (If you are using a magnetic screwdriver with interchangeable
bits, the T-15 bit must be a long bit, at least 5 cm (2 in) overall length).
H Screwdriver with
1
@
8
inch flat blade
H
3
@
16
inch nut driver
H Needle-nose pliers
Tools Required
To Next Page
Loading...
