Getting Acquain
tedWithYourInstrument
Rear-Panel Connectors
The following figure shows the rear panel.
Power Requirements When Using an AC Converter
A single-phase power source with one
current-carrying conductor at or near
earth-g
round (the neutral conductor).
The powe
r source frequency must be
50 or 60 Hz, and an operating voltage
range must be from 100 to 240 VAC,
contin
uous.
System
s with both current-carrying
conductors live with respect to ground
(such as phase-to-phase in multiphase
syste
ms) are not recommended as
power sources.
NOTE. Only the line conductor is fused for
over-
current protection. The fuse is internal
and self-resetting.
WFM4000 and WFM5000 Waveform Monitors User Manual 11
To Next Page
Loading...
