General Safety S
ummary
General Safet
y Summary
Review the following safety precautions to avoid injury and prevent damage to this product or any products connected to it.
To avoid potential hazards, use this product only as specified.
Only qualified personnel should perform service procedures.
While using this product, you may need to access other parts of a larger system. Read the safety sections of the other
component manuals for warnings and cautions related to operating the system.
To Avoid Fire or Personal Injury
Use Proper Power Cord. Use only the power cord specified for this product and certified for the country of use.
Connect and Disconnect Properly. Connect the probe output to the measurement instrument before connecting the
probe to the ci
rcuit under test. Connect the probe reference lead to the circuit under test before connecting the probe
input. D isconnect the probe input and the probe reference lead from the circuit under test before disconnecting the probe
from the m easurement instrument.
Ground the Product. This product is grounded through the grounding conductor of the power cord. To avoid electric
shock, the gr
ounding conductor must be connected to earth ground. Before making connections to the input or output
terminals of the product, ensure that the product is properly grounded.
Observe All Terminal Ratings. To avoid fire or shock hazard, observe all ratings and markings on the product. Consult
the product manual for further ratings information before making connections to the product.
Do not apply a potential to any terminal, including the common terminal, that exceeds the maximum rating of that terminal.
Power Disconnect. The power cord disconnects the p roduct from the power source. Do not block the power cord; it
must remain
accessible to the user at all times.
Do Not Opera
te Without Covers.
Do not operate this product with covers or panels removed.
Do Not Opera
te With Suspected Failures.
If you suspect that there is damage to this product, have it inspected by
qualified service personnel.
Avoid Exposed Circuitry. Do not touch e xposed connections and components when power is present.
Use Proper Fuse. Use only the fuse type and rating specified for this product.
Do Not Operate in Wet/Damp Conditions.
Do Not Operate in an Explosive Atmosphere.
Keep Product Surfaces Clean and Dry.
Provide P roper Ventilation.
Refer to the manual’s installation instructions for details on installing the product so it has
proper ventilation.
Waveform Rasterizers Quick Start User Manual iii
To Next Page
Loading...
Need help?
General
