This procedure can be done within 30 seconds after the reset.
Sum
1
min to
the
set time.
1- Press for 5 sec. the push
button P3 of the transmitter;
the buzzer will sound 1 beep,
release and re-press within 5 sec. the
push button P3 of the transmitter 5 times,
the buzzer will sound 1 beep at each pres-
sure and at the end it will sound 3 beeps
(if after 5 sec. the push
button P3 will not be
pressed the buzzer will
sound
4
beeps and exit
from the procedure).
press and
hold fo.r :::~
r-.
r;y
I ~
5 sec.
<,
p,e"5t:,~
r;y
~
Cl. Cl. Cl. Cl. Cl.
Q) Q) Q) Q) Q)
Q) Q) Q) Q) Q)
Ol Ol Ol Ol Ol
1 234 5
Beeeeeep
/
Beep
2- Press the push bulton P3
of the transmitter, the buzzer
will sound one beep and the
courtesy light turns on, the
time to be memorised starts.
press on:;~~ start tieount
e Beep
CO
wait 5 sec.
<,
-:/
Beep
1
Beep Beep
2 3
3- After the desired time press
again the push button P3 of the
transmitter in order to exit and
memorise the courtesy light time,
the light turns off.
pres~s Stop and memorize
';;: ~ thet;me
e
CO'
Beep
(WARNING learning is necessary only if using the magnetic.contact, inputs 22-23)
This procedure can be done within 30 seconds after the reset.
1- Press for 5 sec. the push
button P3 of the transmitter;
the buzzer will sound 1 beep,
press and
hold for 5 s'c.
r
P3 ~
~ Gj'
Beep
5 sec.
>
BeepBeeeeeep
2- You have entered the
memorization of the dos-
ing time. In the memoriza-
tion function the move-
ment is done manually,
in order to move the door
use the opening and dos-
ing push buttons.
release and re-press within 5 sec. 10
times, the buzzer will sound 1 beep
press,10
times
v/
P3 ~)
Beep' 'Beep
CO'
(if after5 sec. the push but-
ton P3 will not be pressed
the buzzer will sound 4
beeps and exit trom the pro
cedure).
~~ wait5sec.
Cl. Cl. Cl. Cl. Cl. Cl. Cl. Cl. Cl. Cl.
Q) Q) Q) Q) Q) Q) Q) Q) Q) Q)
Q) Q) Q) Q) Q) Q) Q) Q) Q) Q)
Ol Ol Ol Ol Ol Ol Ol Ol Ol Ol
1 2 3 4 5 6 7 8 9
10
3- Place the door in totally
opened position, the buzzer
will sound 1 beep.
Beep
open
~
Beep
1
4- Place the door in totally dosed
position, the buzzer will sound 1
beep and the control unit goes
back to the normal functioning
mode. •
~ Beep
~~~-=,I
~ll
:r- _
dose