81www.behnke-online.de
GB
Instructions SIP intercoms series 20-0001BS, 20-0014BS, 20-0016BS
Commissioning and configuration
Operating mode relay 2 Default: 9
12 0 # deactivated
1 # Door opener relay with NC contact, 2 codes for indoor intercom station
2 # Door opener relay with NC contact, 2 codes for code lock
3 # Door opener relay with NC contact, 1 code for indoor intercom station,
1 code for code lock
4 # Door opener relay with NO contact, 2 codes for indoor intercom station
5 # Door opener relay with NO contact, 2 codes for code lock
6 # Door opener relay with NO contact, 1 code for indoor intercom station,
1 code for code lock
7 # Connection indicator for outgoing connections
8 # Connection indicator for incoming connections
9 # Connection display for outgoing and incoming connections
10 # Additional bell at the beginning of a direct call
11 # Additional bell during the establishment of a direct call
12 # Additional bell during ringing
13 # Fault indication
In operating modes 1 to 6, the relay is operated as a door opener relay. You can choose between
a normally open (NO) and normally closed (NC) contact. With the normally open contact, the switch-
ing contact is normally open and will only be closed when the door is to be opened.
With the normally closed contact it is exactly the opposite: the switching contact is normally closed
and will only be opened when the door is to be opened.
Configuration step 13 sets how long the switching contact will be switched. Configuration steps 14
and 15 can be used to define two codes that apply to the indoor intercom station (phone receiving
the call) or the code lock (available via keypad or display), depending on the selected operating
mode.
In all other operating modes, the switching contact behaves like a normally open contact.
So it is usually open.
In operating mode 10, configuration step 13 can be used to define how long the additional bell is
activated at the beginning of the direct call.
In the 'Fault indication' operating mode, a fault is considered to occur when the device no longer
has a valid network connection or when a registration with the SIP server has failed.
To Next Page
Loading...
