EasyManuals Logo

Telit Wireless Solutions ME910G1 Series User Manual

Telit Wireless Solutions ME910G1 Series
97 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
ME910G1 HW Design Guide
1VV0301593 Rev.3 Page 87 of 97 2020-03-24
Wireless notice
This device complies with FCC/ISED radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS102
of the ISED radio frequency (RF) Exposure rules. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter. The antenna should be
installed and operated with minimum distance of 20 cm between the radiator and your body.
Le présent appareil est conforme à l'exposition aux radiations FCC / ISED définies pour un
environnement non contrôlé et répond aux directives d'exposition de la fréquence de la
FCC radiofréquence (RF) et RSS102 de la fréquence radio (RF) ISED règles d'exposition.
L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne ou
autre émetteur. L'antenne doit être installée de façon à garder une distance minimale de 20
centimètres entre la source de rayonnements et votre corps.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.
List of applicable FCC and ISED rules
Model
Applicable FCC Rules
Applicable ISED Rules
ME910G1-W1
47 CFR
Part 2, 22, 24, 27, 90
RSS: 132 Issue3, 133 Issue 6,
130 Issue 2, 139 Issue 3;
RSS-Gen Issue 5
ME910G1-WW

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions ME910G1 Series and is the answer not in the manual?

Telit Wireless Solutions ME910G1 Series Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelME910G1 Series
CategoryGSM/GPRS Modules
LanguageEnglish

Related product manuals