Telos Hx1 - Factory Default Configuration Settings

32 | Section 4
Factory Default Conguration Settings
ese settings will work in most cases and should be considered to be a “starting point”.
e following is the Factory Default Conguration for the SETTINGS, OPTIONS, and
Internal Telephone Network/Call Progress Tone Detection (CPTD) DIP switches:
Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8
SETTINGS OFF OFF OFF OFF OFF ON ON OFF
Bits 1 and 2 EQ LO, xed dB gain adjustment => 0 dB gain
Bits 3 and 4 EQ HI, xed dB gain adjustment => 0 dB gain
Bits 5 and 6 Ducker dB gain adjustment => -6 dB ducking
Bits 7 and 8 AGC and Noise Gate settings
=> AGC is FULL, Noise Gate is OFF
Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8
OPTIONS ON OFF OFF OFF OFF OFF OFF OFF
Bits 1 and 2 DDEQ conguration => Dynamic EQ is enabled
Bits 3 and 4 Auto-Answer conguration => feature is OFF
Bit 5 Send gain to phone => feature is OFF
Bit 6 Hx2 internal mix-minus enable => feature is OFF
Bit 7 Feedback Reduction enabled => feature is OFF
Bit 8 Reserved
Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8
INTERNAL OFF OFF OFF OFF OFF OFF OFF OFF
Bits 1 through 4
Telephone Network conguration => USA, Canada
Bits 5 through 8
Call Progress Tone Detection => USA dial tone