Telrad BreezeCOMPACT 3000

To Next Page

To Previous Page

Chapter 3 - Operation and AdministrationBS Menu

Chapter 3: Operation and Administration

BS Menu

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

BreezeCOMPACT System ManualBreezeCOMPACT System Manual

The valid range is from 0 to 69.

A change in the UL Permutation Base takes effect after the next reset.

3.7.2.2.1.2 Downlink Data Zone

The Downlink Data Zone menu enables you to view/update the values configured for the following parameters:

 Basic Rate for Management

 Basic Rate for Data

 DL Data Permutation Base

3.7.2.2.1.2.1 Basic Rate for Management

The downlink basic rate for unicast and broadcast management traffic (non-HARQ traffic in reuse 1 region):

 ctcQpskOneOverTwoTimesSix (QPSK 1/2 Repetition 6)

 ctcQpskOneOverTwoTimesFour (QPSK 1/2 Repetition 4)

 ctcQpskOneOverTwoTimesTwo (QPSK 1/2 Repetition 2)

 ctcQpskOneOverTwo (QPSK 1/2)

 ctcQpskThreeOverFour (QPSK 3/4)

 ctcQamSixteenOneOverTwo 16-QAM 1/2

 ctcQamSixteenThreeOverFour (16-QAM 3/4)

 ctcQamSixtyFourOneOverTwo (64-QAM 1/2)

 ctcQamSixtyFourTwoOverThree (64-QAM 2/3)

 ctcQamSixtyFourThreeOverFour (64-QAM 3/4)

 ctcQamSixtyFourFiveOverSix 64-QAM 5/6

The default is ctcQpskOneOverTwo (QPSK 1/2).

A change in the Basic Rate for Management takes effect after the next reset.

3.7.2.2.1.2.2 Basic Rate for Data

The downlink basic rate for HARQ data traffic in reuse 1 region: