Telstra 13450 - Remote Access Code; Message Alert Tone

56
To set number of rings with the telephone base:
Press
when idle, then press SELECT to select Answering system.
Press
p
q
to scroll to Ans sys setup, then press SELECT.
Press
p
q
to scroll to # of rings, then press SELECT.
Press
p
q
to scroll to selectt 6, 5, 4, 3 or 2, then press SAVE.
REMOTE ACCESS CODE
A two-digit security code is required to access the answering machine remotely
from any touch-tone telephone. The preset code is 00. You can set the code from
00 to 99.
To set remote access code with a cordless handset:
Press
when idle.
Press
or to scroll to Answering sys, then press .
Press
or to scroll to Ans sys setup, then press .
Press
or to scroll to Remote code, then press .
Enter a two-digit number, then press
.
To set remote access code with the telephone base:
Press
when idle, then press SELECT to select Answering system.
Press
p
q
to scroll to Ans sys setup, then press SELECT.
Press
p
q
to scroll to Remote code, then press SELECT.
Enter a two-digit number, then press SAVE.
MESSAGE ALERT TONE
When the message alert tone is set to On, and there is at least one new message,
the telephone base beeps every 10 seconds.
The message alert tone is preset to
Off. There is no audible alert at the handset.
To set message alert tone with a cordless handset:
Press
when idle.
Press
or to scroll to Answering sys, then press .
Press
or to scroll to Ans sys setup, then press .
Press
or to scroll to Msg alert tone, then press .
Press
or to scroll to On or Off, then press .
To set message alert tone with the telephone base:
Press
when idle, then press SELECT to select Answering system.
Press
p
q
to scroll to Ans sys setup, then press SELECT.
Press
p
q
to scroll to Msg alert tone, then press SELECT.
Press
p
q
to scroll to On or Off, then press SAVE.
1.
2.
3.
4.
1.
2.
3.
4.
5.
1.
2.
3.
4.
1.
2.
3.
4.
5.
1.
2.
3.
4.