Telstra 13450 - Getting Stared; Location; Setting up

9
GETTING STARED
LOCATION
Place your Telstra 13450 within 2 metres of the mains power socket and telephone
socket so that the cables will reach.
Make sure it is at least 1 metre away from other electrical appliances to avoid
interference. Your Telstra 13450 works by sending radio signals between the base
and handset/pendant. The strength of the signal depends on where you locate the
base. Putting it as high as possible ensures the best signal.
The maximum range between the base station and the handset is approximately 300
meters.
SETTING UP
Telephone base installation
Plug the mains power adapter cable into the base station, plug the other end of
the mains power adapter into a mains power wall socket.
1.
Note:
desk.
Telephone
line cord
If you have DSL high-speed

included) is required.
Telephone base
power adapter
Mains power
wall socket
Telephone
wall jack
Curly handset
cord jack
Telephone line jack
Power cord jack