Telstra T-BOX - LETS GET SET; PAIR YOUR T-BOX REMOTE CONTROL TO YOUR T-BOX

13
LET'S
GET SET
Get ready to be entertained! The Getting Started Guide will help you connect
your T-Box
®
toyourTVaerialcableandTVset.Justfollowtheon-screenprompts
to set up your preferences and BigPond
®
broadband connection.
Once that’s done, your T-Box will check for any software updates and install
them for you. Please don’t try to use your T-Box until after your T-Box restarts
itself with any new software that might be available. Then you can enjoy all the
very latest features – and everything your T-Box has to offer. But rst, here’s
some more in-depth information about the steps that you'll go through in the
on-screen instructions.
Please connect your T-Box to your TV as described earlier in this guide and
switchonyourT-BoxandTV.There’snophysical‘on/off’buttonontheboxitself.
Please use the Power button on the top right corner of your remote control.
•Pressthepowerbuttonontheremotefor3secondsuntilyouseetheonscreen
message ‘Entering sleep mode; please wait.’
•Thenswitchofffromthepowerpoint.NeverpullthecordoutoftheT-Boxdirectly
as it could cause issues with the hard drive of your T-Box
PAIR YOUR TBOX REMOTE CONTROL TO YOUR TBOX
YouneedtopairyourremotecontrolwithyourT-Box,tomakesurethetwo
devices are ‘talking to each other’ properly.
First, check page 11 to make sure you’ve prepared your remote and activated the
batteries. Then just use your remote control to enter the pairing code shown on
your TV screen.
Re-enter the code when you’re asked to, and conrm the connection. It’s that easy.
If you ever need to pair your remote control again, refer to page 43 for
instructions on using the Reset Button under your T-Box.
WARNING: Before disconnecting the power supply, rst turn your T-Box off.
Here is how to correctly power off your T-Box:
Note: If you’ve previously used your remote with another T-Box, or you’ve just
resetyourT-Box,you’llneedtocancelanypreviouspairingcodes.Youcandothis
by pressing and holding the remote’s 1 and 7 buttons together for 5 seconds.