Document Version: V1.3
92
Set Night Vision Mode of the Camera
Only available in some models of NVR. The actual product prevails.
Assume that you want the monitoring images of D1, D2, D3, and D4 cameras to be colored during
the day and night, you can modify the night vision mode of the cameras.
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Navigate to Configuration > Channel > Image.
Step 3 Set the night vision mode of the D1 camera.
1. Select Channel, which is D1 in this example.
2. Click the drop-down list of Night Vision Mode to modify the night vision mode, which is
Full Color in this example.
Step 4 Adjust the night vision mode of other channel cameras.
Click Sync to at the bottom of the page, and select the channels to synchronize the image
parameter configuration of the D1 camera, which are D2 to D4 in this example.
Step 5 Click Save.
---End
After the setting completes, the monitoring images of D1, D2, D3 and D4 cameras are in color
during the day. The white supplement light is enabled at night so that the monitoring images are
also in color.
To Next Page
Loading...