Tenda N3L-4H - Check Alarm Notification of Exception Detection

Document Version: V1.3
23
4.3.4 Check Alarm Notification of Exception Detection
If you want to check the exception alarm notification, you can click the alarm icon in the
upper-right corner of the GUI (a red dot on the upper-right of the icon indicates that there is a new
alarm). Configure the linkage mode of the related exception type as Pop-up Window on the
Exception Detection page first.
After you click the alarm icon on the upper-right corner of the GUI, the following figure
appears.
If the content of the Channel parameter is empty, it indicates that the alarm notification
does not involve the channel. If the content of the Handle parameter is empty, it indicates
that the alarm notification does not support handling here, or the problem no longer
exists.
Parameter description
Parameter
Description
Alarm time
Specifies the time when an alarm event occurs.
Alarm/Error
Specifies the alarm type.
Channel
Specifies the channel for triggering an alarm.
Handle
Click to redirect to the corresponding page to handle the exceptions.