Document Version: V1.3
109
Step 4 Set the schedule of other channel cameras.
Click Sync to at the bottom of the page, and select the channels to synchronize the image
parameter configuration of the D1 camera, which are D2 to D4 in this example.
Step 5 Click Save.
---End
After the setting completes, the system will enable the D1, D2, D3 and D4 cameras to record
according to the above schedule.
4.6.4 Alarm Management
On the alarm management page, you can configure alarm events and the related information. If an
alarm is triggered within the arming schedule, the system will alarm and record according to the
linkage action you set.
Motion Detection
Overview
Navigate to Configuration > Alarm > Motion Detection.
The motion detection function refers to the detection and alarm of moving targets. When a
moving target appears on the monitoring image and the moving range reaches the threshold
corresponding to the preset sensitivity, the system will alarm and record according to the linkage
action you set.
To Next Page
Loading...