Tenda N3L-4H - Page 129

Document Version: V1.3
121
4. Set the linkage action.
(1) Set the linkage action of the camera D1.
Click Linkage Action, and select alarm methods, which are Send Email and Message
Notification in this example. Then select the recording channel, which is D1 in this
example.
(2) Set the linkage action of other channel cameras.
Click Sync to at the bottom of the page, and select the channels to synchronize the
Linkage Action of the D1 camera, which are D2 to D4 in this example.
(3) Click Save.