Tenda N3L-4H - Page 132

Document Version: V1.3
124
Parameter
Description
Arm
Used to set an arming schedule.
Click this button to draw the audio alarm or light alarm time in the timetable
below.
Clear
Used to clear the time that has been set in the timetable below.
Click this button to clear the audio alarm or light alarm time in the timetable
below.
Edit
Used to edit the audio alarm or light alarm schedule of a specific time.
Clear
Used to clear the current arming schedule.
Sync to.
Used to synchronize the current schedule with other channels.
Configure Motion Detection and Sound & Light Alarm
Scenario: Assume that you have set up a monitoring network with an NVR, installed four cameras
and bound D1 to D4 respectively.
Requirement: The human detection function is enabled for all cameras at 8:00 to 22:00 from
Monday to Friday. When the sound & light alarm is triggered, an alarm notification is pushed to
the TDSEE app and triggers the corresponding channel for recording.
Solutions: Configure the Motion Detection and Sound & Light Alarm functions to meet this
requirement.
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Set the motion detection.
1. Navigate to Configuration > Alarm > Motion Detection.
2. Set the motion detection function of the camera D1.
(1) Set Channel, which is D1 in this example. Enable the Motion Detection function.
(2) Enable the Human Detection function, and adjust the sensitivity as required.
(3) Click Save at the bottom page.