Document Version: V1.3
129
4. Set the light alarm function of camera D1.
(1) Set Channel, which is D1 in this example. Click Light Alarm, and then enable the
Light Alarm function.
(2) Set the duration of the lighting flash as required. The following figure is for reference
only.
(3) Set the light alarm schedule, which is 8:00 to 20:00 from Monday to Friday in this
example.
(4) Click Save at the bottom page.
5. Set the light alarm function for other channel cameras.
(1) Click Sync to at the bottom of the page, and select the channels to synchronize the
light alarm function of the D1 camera, which are D2 to D4 in this example.
(2) Click Save.
Step 4 Use TDSEE App to add the NVR. Refer to Manage the NVR Through TDSEE App for the
related steps. (If set, please skip.)
---End
After the setting completes, if the system detects an alarm from D1 to D4, it will audio and light
alarms and push an alarm notification and image to the TDSEE App, and trigger the corresponding
channel to record at the same time.
To Next Page
Loading...