Tenda N3L-4H - Page 190

Document Version: V1.3
182
Parameter
Description
Custom Diagnosis
Specifies the network diagnosis method.
-
Ping: Used to check whether the connection is correct and the
connection quality.
-
Traceroute: Used to detect the route from the NVR to the destination IP
address.
Target Address
Specifies the target address to be detected. IP address and domain name are
supported.
Packet Size
Specifies the size of a single data packet. It is available only when Custom
Diagnosis is set to Ping.
Packet Number
Specifies the number of data packets detected by a single Ping. It is available
only when Custom Diagnosis is set to Ping.
Max. Hop
It is available only when Custom Diagnosis is set to Traceroute.
Specifies the maximum number of hops (maximum lifetime) detected by
Traceroute. It means the maximum number of routes that a data packet can
pass to reach the destination IP address after it leaves the LAN of the NVR.
Execute One-key Diagnosis
Assume that you want to diagnose the network connectivity and network quality of all channels.
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Navigate to Maintenance > Diagnosis.
Step 3 Click One-key Diagnosis.
---End