Document Version: V1.3
39
4. Select the preset you added, set PTZ speed and the dwell time to reach the preset, and
click OK.
5. Repeat substep 4 to add the other preset and click Save.
---End
Call Preset
Control the camera to rotate to the monitoring position of the specific preset.
Before the preset is called, you need to Set the Preset first.
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2
Click Live View, hover the mouse over the camera channel you want to perform PTZ
control, and click at the bottom of the channel.
Specifies the dwell time at the preset.
Specifies the speed at the preset.
Specifies the preset used by the
patrol. It needs to be added in
advance.
-
Click to re-edit the used preset.
-
Click to move the preset up. Unavailable
Click to move the preset down.
Unavailable in the last preset.
-
Click to delete the corresponding preset.
After the patrol parameters are adjusted, click
Specifies the preset of the patrol.
To Next Page
Loading...