Tenda TEG1024D User Manual

2
PnP, full-duplex, flow control, and can choose the best network connectivity
mode automatically to avoid the complex setting procedure.
z Supports auto MDI/MDIX function; predigest the network span and
maintenance.
z Supports IEEE802.3x flow control for full-duplex, and back pressure flow
control for half-duplex.
z As high as 32/48Gbps backplane bandwidth; supports non-blocking
wire-speed forwarding.
z Supports store-and-forward switching method.
z Internal universal power supply.
z Supports MAC address auto-learning function, integrated 8K MAC
address table.
Checklist
Please check the articles carefully after you open the packing as below:
9 One 16/24-Port Gigabit Ethernet switch
9 Mounting ears, eight screws, four rubber feet
9 One power cord
9 This manual
If any of listed items are mismatched, missing or damaged, please contact
the Tenda reseller from whom you purchased for replacement immediately.

Tenda TEG1024D Specifications

General

MAC address table	8000 entries
Store-and-forward	Yes
Maximum data transfer rate	48 Gbit/s
Supported data transfer rates	10/100/1000 Mbps
Networking standards	IEEE 802.3, IEEE 802.3ab, IEEE 802.3u, IEEE 802.3x
Copper ethernet cabling technology	1000Base-T, 100Base-TX, 10Base-T
Wi-Fi	No
Size (imperial)	11 \
Power requirements	100 - 240 V
Networking features	Ethernet, Fast Ethernet, Gigabit Ethernet
Connectivity technology	Wired
Switch type	Unmanaged
Supported network protocols	UPnP
Basic switching RJ-45 Ethernet ports quantity	24
Certification	QA
Product color	Blue
Power consumption (typical)	20 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	85176990