5
Remarks: 1000Mbps port may be flashing together with Link/Act when it
transfers datum.
Before Connecting to the Network
TEG1016D/1024D supports the desktop and rack-mountable installation.
Before connecting to the network, please pay attention to the following
instructions:
¾ Don’t put heavy articles on the Switch.
¾ Power sockets and equipments should be within 1.5 meters of the
Switch.
¾ Check power supply to confirm the safe connection.
¾ Make sure there’s adequate space for proper heat dissipation and
adequate ventilation around the Switch.
¾ When installing the Switch on a level surface, attach the rubber feet to
the bottom of the device in case of being scratched or scratching other
surfaces.
Rack-mountable Installation
The TEG1016D/1024D Gigabit Ethernet Switch also supports rack-mount. If
you want to install the device in this way, please refer to the following
instructions to set up.
To Next Page
Loading...
