300M Wireless AP 
37 
4. Safety and Emission Statement 
 
 
CE Mark Warning 
This is a Class B product. In a domestic environment, this product may cause radio interference, in 
which  case  the  user  may  be  required  to  take  adequate  measures.  This  device  complies  with  EU 
1999/5/EC. 
NOTE: (1) The manufacturer is not responsible for any radio or TV interference caused by unauthorized 
modifications to this equipment. (2) To avoid unnecessary radiation interference, it is recommended to 
use a shielded RJ45 cable. 
 
 
FCC Statement 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation. 
 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference 
to radio communications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, which can 
be  determined  by  turning  the  equipment  off  and  on,  the  user  is  encouraged  to  try  to  correct  the 
interference by one of the following measures: 
-  Reorient or relocate the receiving antenna. 
-  Increase the separation between the equipment and receiver. 
-  Connect  the  equipment  into  an  outlet  on  a  circuit  different  from  that  to  which  the  receiver  is 
connected. 
-  Consult the dealer or an experienced radio/TV technician for help. 
FCC  Caution:  Any  changes  or  modifications  not  expressly  approved  by  the  party  responsible  for 
compliance could void the user's authority to operate this equipment. 
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 
The  manufacturer  is  not  responsible  for  any  radio  or  TV  interference  caused  by  unauthorized