300Mbps Wireless Access Point
last added device as the bridge used channel (You can also change
the channel according to your need. All the devices must at the
same channel, thus the bridge can be established.)
4.1.2.3 Wireless Repeater Mode
Repeater Mode can repeat and amplify wireless signals to extend
wireless network coverage. In this mode, wireless clients are allowed to
connect.
When two LAN’s transmission distance is over the wireless device’s
maximum transmission value, or there is much block among devices, you
can use the Repeater mode to deal with these problems by adding MAC
addresses. The topology shows below:
Select wireless repeater on the drop-down box of WDS mode and the
page will show as below.
To Next Page
Loading...
Need help?
General
