Tenda W302A User Manual

300Mbps Wireless Access Point
Users can select the mode according to need. Please refer to Chapter
4.1.2 for detailed introduction.
Click “Enable Scan”. AP will scan the available wireless device nearby
automatically and display them under the list (see the picture below).
Select the AP which you need to bridge and click “Next” to enter the
security setup interface. On the other hand, you can input the MAC
address of wireless device which you want to bridge manually and select
the corresponding channel.
After finish the settings, click “Next” to enter the “Security Setting” option

Tenda W302A Specifications

General

Brand	Tenda
Model	W302A
Category	Wireless Access Point
Language	English