Tenda W302A - Wireless Clients; Quick Setup; AP Mode

300M Wireless AP
16
3.2.4 Wireless Clients
Click Status > Wireless Clients to enter screen below. This section displays information of connected clients
(if any).
3.3 Quick Setup
This device supports 3 working modes for expanding wireless network coverage. You can select one as you
need.
AP Mode: In this mode, the AP connects to the remote device via an Ethernet cable and then clients can
connect to the AP wirelessly, thus achieving the conversion between wired networks and wireless networks.
And without any configuration, you can achieve network sharing among multiple clients.
WDS Mode: In the WDS mode, the AP and the remote device should support WDS feature. By scanning
each other and keeping their SSIDs, channels, security modes and keys the same, they can bridge
successfully. Then clients can connect to the AP wirelessly for Internet access.
AP Client Mode: In this mode, what you need to do is to scan the remote device’s signal and bridge it
successfully without any configuration on the remote device. Then clients can connect to the AP wirelessly
for Internet access.
3.3.1 AP Mode
Click Quick Setup to enter screen below:
Configuration Procedures:
1. SSID: This field is optional. You can change your SSID here if you want to;