Teradek, LLC 2020. All rights reserved. v1.3-0620
WIRELESS SETTINGS - VIDEO QUALITY
The Video Quality menu lets you adjust the balance between your signal’s maximum
range and quality according to the number of antennas used to transmit fine
information. Bolt 4K has three picture quality levels that vary based on the lowest
quality link or the furthest receiver.
13
● Auto Mode
- (Default) Transmitter automatically determines how
many fine antennas are needed based on the range and
signal quality
● Longer Distance Mode
- (One fine antenna) Maintains the maximum range in
situations where other sources of interference might
be present, but will slightly reduce your video signal’s
maximum quality
● Better Quality Mode
- (Two fine antennas) Maintains higher signal quality, but
reduces the maximum range
● Best Quality Mode
- (Three fine antennas) Ideal for complex, high contrast
scenes that require the highest possible quality
● Low Power Mode
- (One fine antenna with shorter range) Reduces the
transmitter's total power consumption by about 1.5W,
and may reduce any unwanted interference in multi-
system environments
PAIR
Enable pairing on transmitters and receivers. Bolt 4K units purchased as a set (TX
and RX) are paired by default, requiring no additional configuration. If the units were
purchased separately, or if they have never been paired, you will need to complete
the pairing process (page 5). Once Pairing is complete, there is no need to repeat the
process unless the TX or RX's OSD name has been modified, or if the region has been
changed. To confirm if your devices were paired successfully, open either the Unpair
menu (TX) or the Switch TX menu (RX) and verify that the paired device
is listed.
NOTE: Before starting the pairing process, ensure that both the transmitter and
receiver have the same firmware version and have Bluetooth enabled.
UNPAIR
Unpair and remove devices from your unit's paired device registry. This feature is
useful in situations when paired devices are no longer being used and need to either
be removed from the registry, or replaced. Transmitters can store up to six paired
receivers in its device registry.
To Next Page
Loading...
