28 EN
EN
3. Bin lift operation
37878
05-2017
ã Terberg Machines B.V., IJsselstein, The Netherlands
All rights reserved. No part of this book may be reproduced, stored in database or retrieval system, or published, in any form or in any way,
electronically, mechanically, by print, photoprint, microfilm or any other means without prior written permission from the publisher.
3.11.5
Diagnostic System - Settings
Raise lifting chairs (Travel height), Change over 2-wheel / 4-wheel
SETTINGS
SETTINGS:
REVERSE RAISE:
SETTINGS:
REVERSE RAISE:
POSITION: 00.0%
REVERSE RAISE:
POSITION: 0 %
REVERSE RAISE:
POSITION: 0 0 %
REVERSE RAISE:
POSITION: 0 0. 0 %
MONITOR
push 3x
confirm withchange with
confirm withchange with
confirm withchange with
REVERSE RAISE:
POSITION: 00.0%
Raise lifting chairs
during reverse
(Travel height)
push 3x
SETTINGS:
AUTO SWITCH 4W/2W:
SETTINGS:
AUTO SWITCH 4W/2W:
OPTION ON
AUTO SWITCH xxxxxxx:
OPTION ON
AUTO SWITCH xxxxxxx:
OPTION xxx
MONITOR
push 3x
confirm withchange with
Automatically change over
from 2- to 4-wheel and/or
from 4- to 2-wheel
push 4x
AUTO SWITCH 4W>2W:
OPTION ON
AUTO SWITCH xxxxxxx:
OPTION OFF
confirm withchange with
with keys you can display the
next / previous message
When exceeding the max. or min. value the following message appears:
Enter value 999 for factory settings.
! VALUE OUT RANGE !
The functions ‘4W>2W’ and ‘2W>4W’ are not accessible
if ‘AUTO SWITCH 4W/2W’ is not turned on (Option OFF).
AUTO SWITCH 2W>4W:
OPTION ON
To Next Page
Loading...
